Ricks beading loom delivers a perfect finish every time! You’re left with only TWO WARP THREADS to weave back in after you complete your project. The same project woven on an ordinary loom leaves you with lots of messy warp threads to weave back in. With The Ricks Beading Loom, you never have more than two warp threads left to deal with.

The patented design of the ricks beading loom is extremely clever. Everything has been thought of to make the whole process as easy as possible. The working frame is at uneven heights allowing you to work upward as you progress, meaning you wont need to bend your back to see what you are doing. There are magnets at the end of your ricks beading loom so you can put your needle down and guarantee it won’t get lost. The warp thread holding rods are easy to remove allowing to take your loom of without any struggle. The peg system for holding your warp thread allows you to easily tighten or loosen your warp threads to get the prefect tension. The wing nuts allow you to vary the length of your project from under 1 inch to over 12 inches. Set up is extremely quick with a maximum width of 40 beads taking only 5 minutes to prepare.

Once the weaving of a piece has been completed, the finishing time after this is what often puts people off from doing looming. With the ricks beading loom this is almost completely irradicated! With just two warp threads remaining, the total time for finishing has been reduced by up to 90%!

The ricks bead loom is made of solid wood with metal to ensure durability and quality. Start your bead looming revolution today!